Couplings allow you to attach a Bowden tube to the hotend or extruder

RC-modeller og andre præcisionsmaskiner

54 Rated Voltage: 12V Rated Current:0

5mm (Ender 3/ CR20)

hvilket gør det til det perfekte valg for både begyndere og erfarne brugere

TPM - Wash Solvent - 10L Raise 3D - Hyper Speed - ABS Couplings allow you to attachWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 10 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs