Loosen the two screws above the spoiler and then the four screws on the sides of the spoiler bracket

Connect the Power Up module to the LED lights and secure it at a suitable location inside the body

Front LEDs Extremely bright front LEDs easily installed on the front bumper

Attention: The LEDs from the Wald Light Kit can only be operated with the Power Up module

to protect them and prevent them from coming into contact with sharp edges

Triple Spike DBXL 2.0 / DBXL-E 2.0 Loosen the two screws aboveExtremely bright rear LED, which is easily attached to the rear spoiler bracket. To install, simply clamp the light and connect it to the existing front LED connector. The installation is very straightforward and can be done without much effort. Installation Instructions Loosen the four screws on the spoiler bracket. Clamp the LED between the struts of the spoiler bracket and lightly tighten the screws again. Ensure that the LED is securely in place