The carbide-tipped C2011 Shaper Cutter is specifically made for use on shapers with 1/2" spindles

ROLL 3000 PSI 1/2"x500' BLACK NEPTUNE 14

back-up and Oring plunger sealing system

and may also be converted for 240 volt application

Honda® Engine with Electric Start 390 cc (13 HP) engine with integrated fuel tank to deliver maximum performance

C.A Technologies 2.5 gallon (NON-ASME) Stainless Steel Non-Agitated Bottom Outlet Pressure Tank - DOUBLE REGULATED 11.6” The carbide-tipped C2011 Shaper CutterIMPORTANT NOTE: IF THIS PRESSURE TANK IS TO BE USED FOR SPRAYING FLAMMABLE MATERIALS, OPERATOR MUST NOT PRESSURIZE THIS TANK MORE THAN 15 PSI TO MEET OSHA REQUIREMENTS. FOR NON ASME PRESSURE VESSELS. IT IS THE RESPONSIBILITY OF THE OPERATOR TO FOLLOW THIS MANDATORY PROCEDURE. This pressure tank is equipped with either single or double air pressure regulation, pressure safety relief valve, tank vent valve, bottom outlet ball valve and four caster